ZMP1103 Electro Pneumatic Training Workbench Pneumatic Trainer Pneumatic Training Equipment
1. Structure
Electro pneumatic trainer is designed for “hydraulic and pneumatic training”, it meets modern pneumatic transmission requirement. Students can learn basic pneumatic circuit control knowledge, and practice hand on ability. Pneumatic trainer combines electrical and mechanical transmission knowledge.
Through this trainer, students can master pneumatic components structure, pneumatic circuit control theory, pneumatic circuit design, and hand on ability for pneumatic trainer.
2. Introduction
1． Workbench has 4 wheels, it is suitable for move and installation. 2 wheels can be lockable. It use aluminum panel, the distance for slot is 25mm, there is quickly plug in and plug out sockets under components, students can plug components on aluminum panel easily.
2. Every pneumatic component is an individual module, it has quickly plug in and plug out sockets, can put in aluminum panel and build pneumatic circuit.
3. Use stainless air compressor, running has low noise, it supply good environment for training.
4. Pneumatic circuit use quickly plug in and plug out leads, it is suitable for students to build pneumatic circuit. Students can combine theory to practice, and practice hand on ability.
5. Add electro pneumatic components than ZMP102.
3. Basic structure
Pneumatic control experiment workbench including experiment workbench, experiment shelf, pneumatic components etc.
Pneumatic components and real equipment: air filter, decrease pressure valve, service unit, hand-operated direction valve, pneumatic control direction valve, strike valve, check valve, throttle valve, exhaust valve, single acting cylinder, double acting cylinder etc.
